Vocera Badge Bedienungsanleitung PDF herunterladen

Vocera Batteries and Chargers

About Vocera Batteries and Chargers

The Vocera badge uses custom lithium ion batteries.

Two battery options are available: standard and high-

capacity. These small, lightweight batteries snap onto

the back of the badge.

Vocera batteries may be charged only in a Vocera

battery charger. Battery chargers are also available in

two types: single-bay and eight-bay. The single-bay

charger, which allows the badge to be used while it is

in the charger, is ideal for individual use. The eight-

bay charger is suited for group use as it can

simultaneously charge eight badges or batteries using

only one power adaptor.

When to Charge the Battery

New batteries must be charged before use. It takes

approximately 90 minutes to fully charge a battery.

Once the badge is in use, there are several easy ways

to check whether you need to recharge the battery:

1. The green indicator light on the top of the badge

turns red and blinks rapidly.

2. The battery-level indicator on the badge display

shows empty.

3. An alert tone or message plays at regular

intervals. (These audible warnings may be

disabled by the system administrator on request.)

Preparing the Charger

Before you use a charger, read the safety instructions

on the reverse side of this page.

To prepare the charger for use, insert the single-

pronged plug into the outlet in the charger, and plug

the two-pronged power plug into a 110 V AC outlet.

The indicator light on the top of the charger shows

one of the following conditions:

Charging the Battery Without

the Badge

1. Slide the battery latch toward the bottom of the

badge and remove the battery with your other

hand.

2. Insert the battery into the charger, making sure

the battery label points toward the middle of the

charger slot.

The green indicator light on the top of the

charger will begin to blink when the battery is

positioned correctly, and it will continue to blink

while the battery is charging. When the indicator

glows steadily, the battery is fully charged.

3. Remove the battery from the charger.

Fully Charged

Partially Used

Empty

Indicator Meaning

Light off There is no battery or badge in the

charger, or the battery is not seated

properly.

Blinking green The battery is charging.

Steady green The battery is fully charged.

Red The battery is unable to charge, or

there is a problem with the charger.

If the charger works when you try

to charge a different battery,

discard the original battery (see

Additional Instructions Related to

Battery Safety) and charge a new

one.

Single-bay Charger Eight-bay Charger

1 2 3

Inhaltsverzeichnis

Seite 1 - Vocera Batteries and Chargers

Vocera Batteries and ChargersAbout Vocera Batteries and ChargersThe Vocera badge uses custom lithium ion batteries. Two battery options are available:

Seite 2

4. Slide the holes in the top of the battery over the small pegs in the badge’s battery compartment.5. Press down gently to seat the battery in the ba

Seite 3 - Battery Safety

Additional Instructions Related toBattery Safety1. Use only the batteries supplied with the product or Vocera-approved replacements.2. Do not use the

Kommentare zu diesen Handbüchern

Keine Kommentare

Vocera Badge Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Nein Vocera Badge herunter. Vocera Batteries and Chargers Guide Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern